Home  |  Circuit diagrams  |  Electronics projects  |  Store  |  Links  |  Contact  |  Privacy policy  |  Sitemap

..::::..





Medium Wave Active Antenna

Medium Wave Active Antenna

Notes

This circuit is designed to amplify the input from a telescopic whip antenna. The preamplifier is designed to cover the medium waveband from about 550Khz to 1650Khz. The tuning voltage is supplieb via RV2, a 10k potentiometer connected to the 12 Volt power supply.

RV1 is the gain control allowing weak signals to be amplified or strong signals to be attenuated. The control voltage is applied to gate 2 of TR1, a dual-gate MOSFET, the signal voltage applied via gate 1; the input signal being double tuned via the 330uH coil and the two KV1235 varicap diodes at the MOSFET's input and by the same components at the BF981 MOSFET's drain terminal. Both tuned circuits provide high selectivity across the entire tuning range. To aid stability the MOSFET stage is fed from a 6.2V zener stabilized supply.

To drive low impedance (50 ohm) receivers, the medium output imepedance of the BF981 stage is enhanced by the composite amplifier made from Q2 and Q3. Q2 is operating in common emitter boosting voltage levels by just over 2, Q3 is operating in emitter follower providing the circuit with low output impedance.

Finally this active antenna can be used on other bands by changing the values of the 330uH coils. To perform on multiple bands switches or relays can be used to change the value of the coils.

Circuit by Andy Collinson and David Sayles
Source: zen's circuit directory

..:: Important ::..

Read disclamer, please!

 

Circuit diagrams home  |  Circuit diagrams  |  Electronics projects  |  Store  |  Links  |  Privacy policy  |  Contact